Home > CCNA – Show commands

CCNA – Show commands

March 17th, 2015 Go to comments

Question 1

Explanation

From the output, we learn that the IP address of the neighbor router is 10.1.1.2 and the question stated that the subnet mask of the network between two router is 255.255.255.252. Therefore there are only 2 available hosts in this network (22 – 2 = 2). So we can deduce the ip address (of the serial interface) of Manchester router is 10.1.1.1 -> A is correct

The platform of the neighbor router is cisco 2610, as shown in the output -> C is correct

Maybe the most difficult choice of this question is the answer E or F. Please notice that “Interface” refers to the local port on the local router, in this case it is the port of Manchester router, and “Port ID (outgoing port)” refers to the port on the neighbor router -> E is correct.

Question 2

Explanation

The “show version” command can be used to show the last method to powercycle (reset) a router

show_version.gif

Question 3

Comments (0) Comments
  1. No comments yet.
Add a Comment